Replace Apc Battery While Running

Replace Apc Battery While Running
  • Save

Customers may wish to replace the batteries in their UPS without turning off. It is important to remember that during the brief time that your battery is. Once your battery is replaced you should allow it to charge to 100%, then run a self test:.
I've got to replace my battery for my APC Smart UPS 3000.. . I'm going to try the hotswap, as this battery isn't running any servers.. The best bet would be to call into APC tech support and talk to an apc tech while servicing a unit that is still .
Depends on the specific model. On some you can safely swap the batteries while the unit is live, on others you cannot. Do not attempt this except by the .
Make sure the UPS keeps in contact with its electrical ground at all times.. It generally involves deep-discharching and recharging the battery while the UPS is in a. and run a periodic self-test; they will alert you when replacement is needed.
Run #10 AWG gauge (5 mm2) wire through the access panel, and connect the wires to the. Battery operation is not available while the UPS is in bypass mode.

Add a Comment

Your email address will not be published. Required fields are marked *

one × 3 =